A pipe usually fails inside a wall cavity, which means the visible damage is only a fraction of what's actually happening behind the drywall.
Insulation and drywall removal is targeted, and we coordinate directly with a licensed plumber for the actual pipe repair.
Our Draper, UT technicians locate the main or local shutoff valve immediately if it hasn't been closed already.
Pinpointing the break location prevents unnecessary demolition in the wrong section of wall.
Drywall and insulation come out only where moisture readings confirm saturation, not the entire wall.
Handoff to a licensed plumber is built into our burst pipe process, not left for you to arrange separately.
A burst pipe call has a specific sequence — find the source, stop it, open only what's necessary, and coordinate repair — here's how our Draper, UT crews run it.
If the source is still running, shutoff is priority one.
Pressure testing and moisture tracing help pinpoint exactly where the line failed.
Wall cavity extraction addresses moisture a surface-level approach would miss.
Targeted removal limits the repair scope to what's actually necessary.
Drying continues until wall cavity moisture readings hit dry standard.
Plumbing repair coordination is included so you're not managing two separate contractors.
We'll walk you through locating the shutoff valve over the phone if needed.
Equipment for wall cavity work is brought along by default for burst pipe calls.
We diagnose the leak location and provide a written estimate for extraction and drying before removal begins.
The job isn't done until both drying and repair coordination are confirmed.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
No, we remove drywall only at the confirmed wet line based on moisture readings.
Pipe repair is handled by a licensed plumber we coordinate with, while we manage extraction and drying.
If you can safely reach it, shut off the water at the main or local valve to stop the flow.
Wall cavity drying typically takes 3-5 days depending on how much insulation and framing was affected.
If your address is in or near Draper, a crew can typically respond the same day.
Speak directly with our burst pipe response team.
Call +1-844-578-1604